Ready to Sky Digital Servo Tester/ESC Consistency Tester

Ready to Sky Digital Servo Tester/ESC Consistency Tester

Readytosky Digital Servo Tester/ ESC  Consistency Tester is used to spin up your motors to check spin direction without having to use a receiver. It offers 3 modes to check servos or ESC.

The Display is consists of a 7 segment display and also it has an input port and output port. low-power, cost-effective device which can examine three servo motors at a time. The tester requires a maximum of 6 volts for normal functioning. It also has an electric speed controller (ESC), which is used to check the motor’s current directions A little bigger than a postage stamp, the Simple Servo Tester lets you control two digital or analog servos without using a transmitter or receiver, just plug in your battery pack to start testing. Use it to check your servos before installing them into your models or to center your servos when setting up linkages

.

Features:

1. Input voltage: 4.8-6.0v
2. Screen Display 1.18inch
3. Easy to Read 4 Digit 7 segment Screen
4. Synchronous output servo system and performance for steering gear for precise control of servo control output signal
5. 7 servos can be output and controlled synchronously
6. Plug one of your ESC three-wire cables into the throttle channel of the RC receiver. …
7. Turn on the transmitter and set throttle stick to maximum (full up).
8. Connect the LiPo battery.
9. You will hear a musical tone then two beeps.
10. After the two beeps, lower the throttle stick to full down

Packages Includes:

1 x Ready to Sky Digital Servo Tester/ESC Consistency Tester